Station Programming 2-23
2.2 Station Programming
One-Touch Dialling Button (Assignment)
Allows you to assign a Flexible (CO, DSS, PF) button as an One-Touch Dialling button.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
1. Press the desired Flexible (CO, DSS, PF) button which you
wish to assign as an One-Touch Dialling button.
2. Dial 2.
• The display shows:
3. Enter the desired number (an extension number or a phone
number, etc.).
• Up to 16 digits can be stored.
• To erase an incorrect entry, press the CLR (S2) button or
the TRANSFER (CLEAR) button.
(The TRANSFER button becomes the CLEAR button when using the
overlay.)
4. Press the STORE button.
• The STORE indicator light turns on.
• The display shows the initial programming mode.
— To exit from Station Programming mode: Press [PROGRAM] or lift the handset.
Conditions
• The number can be an extension number, a telephone number, or a feature number.
Up to sixteen digits can be stored on an One-Touch Dialling button.
• To store the telephone number of an outside party, the line access code (9, or 81
through 88) must be stored as the leading digit.
• You can store a number consisting of seventeen digits or more by dividing it and
assigning it in two One-Touch Dialling buttons. In this case, the line access code
should not be stored on the second button.
• You can use 0 through 9, , #, PAUSE, RECALL or FLASH/RCL, CONF and
INTERCOM for storing:
# : change the dialling mode (Pulse to Tone)
RECALL or FLASH/RCL : Register Recall Signal
PAUSE : pause
CONF : — (hyphen)
INTERCOM : for secret dialling
1
2
4
To Next Page
Loading...
