Station Programming 2-7
2.2 Station Programming
Charge Fee Reference
Allows you to see, print out and clear charges. Charges are displayed per extension, CO
line, account code, or the total of each can be referred to. There are seven corresponding
features as follows:
1.) Extension Charge Fee Reference
2.) CO Line Charge Fee Reference
3.) Account Code Charge Fee Reference
4.) Total Extension Charge Fee Reference
5.) Total CO Line Charge Fee Reference
6.) Total Account Code Charge Fee Reference
7.) Account Code Set
Conditions
• System Programming determines the extension that can see charges.
•
An identification code (ID code), set by System Programming, is required to see charges.
• The first display format – Pulse or Pound – is selected by System Programming. This
can be switched manually at each extension.
• You may use the overlay while programming. In this case, the HOLD button
becomes the END button and the REDIAL button becomes the PREV button.
• The currency denomination is programmable by System Programming.
Programming References
• System Programming — Installation Manual
[015] Charge Rate Fractional Point Assignment
[016] Charge Rate Assignment
[117] Charge Display Selection
[118] Charge Verification Assignment
[119] Charge Verification ID Code Set
[125] Assignment of Denomination
Extension Charge Fee Reference
Provides you with the display of each extension charge (telephone rate). You can print
out and clear the displayed meter and charge.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
1. Dial 8.
1
To Next Page
Loading...
