Panasonic KX-TD816E - Single-CO (S-CO) Button

Station Programming 2-27
2.2 Station Programming
Single-CO (S-CO) Button (Assignment)
Allows you to assign a Flexible (CO) button as a Single-CO button.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
1. Press the Flexible (CO) button which you wish to assign as an
S-CO button.
2. Dial 0.
• The display shows:
3. Enter the CO line number as follows.
- 01 through 16: if you are connected to the KX-TD816
- 01 through 54: if you are connected to the KX-TD1232
• The display shows:
(— xx: CO line number)
• To erase an incorrect entry, press the CLR (S2) button or
the TRANSFER (CLEAR) button.
(The TRANSFER button becomes the CLEAR button when using the
overlay.)
4. Press the STORE button.
• The STORE indicator light turns on.
• The display shows the initial programming mode.
— To exit from Station Programming mode: Press [PROGRAM] or lift the handset.
Conditions
• You cannot assign the same CO line to more than one S-CO button on a proprietary
telephone.
• You can assign a CO line to a S-CO and a G-CO button.
CO—
CLR
CO—xx
CLR
1
2
4
AUTO DIAL
STORE
3
CO line number
0