Panasonic KX-TD816E - Two-Way Transfer Button

2-30 Station Programming
2.2 Station Programming
†: Available when the Digital Super Hybrid System is connected to a Digital
Proprietary Telephone capable Panasonic Voice Processing System. (one
that supports digital proprietary telephone integration; e.g. KX-TVP100).
Two-Way Transfer Button (Assignment)
†
Allows you to assign a Flexible (CO, DSS) button as a Two-Way Transfer button.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
1. Press the desired Flexible (CO, DSS) button which you wish
to assign as the Two-Way Transfer button.
2. Dial 84.
• The display shows:
3. Enter the extension number of the Voice Mail.
• The display shows:
(— xxxx: VM extension
number)
• To erase an incorrect entry, press the CLR (S2) button or
the TRANSFER (CLEAR) button.
(The TRANSFER button becomes the CLEAR button when using the
overlay.)
4. Press the STORE button.
• The STORE indicator light turns on.
• The display shows the initial programming mode.
— To exit from Station Programming mode: Press [PROGRAM] or lift the handset.
Conditions
• You cannot enter a non-existent extension or a floating number.*
• The voice mail extension number is acceptable, if the number is assigned in program
[127].
Programming References
• System Programming — Installation Manual
[127] Voice Mail Extension Number Assignment
* Floating Number (FN) is a virtual extension number for resources to make it appear to be an extension.
Refer to the Installation Manual.
1
2
4
AUTO DIAL
STORE
3
VM extension number
8
4
2 WAY-TRANS:
CLR
2 WAY-TRANS:xxxx
CLR