3-4 User Programming (Manager Programming)
3.1 User Programming Instructions
Before entering the programming mode
Before entering programming mode, confirm that:
• Your telephone is on-hook.
• No calls are on hold at your telephone.
Entering the programming mode
To enter the User Programming (Manager Programming) mode:
Press PROGRAM + + + User Password (default:1234)
• The display shows the Initial Message:
USR-PGM NO?→
Notes:
• If nothing is entered in five seconds after the PROGRAM button is pressed, it is
cancelled.
• During the programming mode, your extension is treated as a busy extension.
• Only one proprietary telephone can be in programming mode at any one time.
• The User Password is not shown on the display. The password can be changed by
System Programming.
Programming References
• System Programming — Installation Manual
[120] User Password
In this section, programs [000] through [004] are described. Please refer to the
Installation Manual or consult your dealer when you need to change the following
programs:
• [005] Flexible CO Button Assignment
• [006] Operator / Manager Extension Assignment – Day / Night
• [007] DSS Console Port and Paired Telephone Assignment
• [008] Absent Messages
• [009] Quick Dial Number Set
• [010] Budget Management
• [011] Charge Margin and Tax Rate
• [012] ISDN Extension Number Set
• [013] ISDN Extension Name Set
• [014] Budget Management on ISDN Port
• [015] Charge Rate Fractional Point Assignment
• [016] Charge Rate Assignment
To Next Page
Loading...
