Useful InformationAnswering SystemTelephone System
15
Installation
Preparation
For DSL service users
If the unit is connected to a telephone line with DSL service, you may hear noise
from the receiver or speaker during conversations or the unit may not display
caller’s name and/or phone number properly. We recommend connecting a noise
filter* (contact your DSL service provider) to the DSL telephone line between the
base unit and the telephone line jack.
N Connecting a 2-line telephone jack
For this connection, please use a T-adaptor.
1 2-Wire Telephone Line Cord with TRANSPARENT Plugs
2 4-Wire Telephone Line Cord with GREEN Plugs
N Connecting 2 single-line telephone jacks
2
1
e.g. DSL line is LINE 2.
TRANSPARENT
Plug
GREEN Plug 2-Line Telephone
Jack (CA14A)
TRANS-
PARENT
Plug
Noise
Filter Plug
*Noise Filter
T-adaptor
2
1
e.g. DSL line is LINE 2.
LINE 1
LINE 2
TRANSPARENT
Plug
GREEN Plug
Single-Line
Telephone Jacks
(CA11A)
*Noise Filter
1 2-Wire Telephone Line Cord with TRANSPARENT Plugs
2 4-Wire Telephone Line Cord with GREEN Plugs
TG6500C_Preparation.fm Page 15 Thursday, September 30, 2004 4:54 PM
To Next Page
Loading...
