Panasonic KX-TG6500C - Speed Dialer; Storing Phone Numbers in Base Unit; Dialing Stored Phone Numbers

Useful InformationAnswering System
Preparation
55
Telephone System
Speed Dialer
Storing Phone Numbers
You can store up to 10 phone numbers in the base unit. The dialing buttons ([0] to
[9]) function as memory stations.
Make sure the base unit is not being used.
• If a pause is required when dialing, press [REDIAL/PAUSE] where needed. “” is
displayed when [REDIAL/PAUSE] is pressed. A pause counts as one digit (p. 66).
• When [*] is pressed, “ ” is displayed. When [#] is pressed, “ ” is displayed.
• If a phone number is stored in a memory location which already contains a phone
number, the old number will be erased.
• We recommend you make a note of which phone numbers are stored in which
memory locations.
To erase a stored number
1. Press [PROGRAM], then press [AUTO].
2. Press the memory station number ( [0] to [9] ) for the phone number to be erased.
• A long beep sounds and the phone number is erased.
Dialing a Stored Phone Number
• Speed dial numbers stored in the base unit can only be dialed from the base unit.
1 Press [PROGRAM].
• The IN USE indicator flashes and “”
is displayed.
2 Enter a phone number of up to 32
digits.
• The last digit of the entered number is
displayed.
• If you misdial, press [PROGRAM],
and start again from step 1.
3 Press [AUTO].
4 Press a memory station number
([0] to [9]).
• A long beep sounds and the phone
number is saved.
• To store other numbers, repeat from
step 1.
1 Press [SP-PHONE] or a line button.
2 Press [AUTO].
3 Press a memory station number ([0] to [9]).
• The stored number is dialed.
Base Unit
[SP-PHONE] Memory
Station
Numbers
[REDIAL/PAUSE]
LINE Buttons
[PROGRAM]
[AUTO]
Base Unit
TG6500C_CordlessTel2.fm Page 55 Thursday, September 30, 2004 4:56 PM