Useful InformationAnswering System
Preparation
39
Making Calls
Telephone System
N When the handset is not in use, you can also turn this feature on or off by
performing the following steps:
1. Press [MENU] while the handset is not in use.
2. Scroll to “Voice enhancer” by pressing [d] or [B], then press the soft key
().
3. Select “On” or “Off” by pressing [d] or [B].
4. Press the soft key ( ), then press [OFF].
Using the Base Unit
• To switch to the handset while using the base unit speakerphone:
— If the handset is off the base unit, press the line soft key ( ) or ( ) on
the handset, then press [SP-PHONE] on the base unit.
— If the handset is on the base unit, just lift up.
• The line buttons show the status of each line (p. 40).
To adjust the speaker volume during a conversation
To increase volume, press [B]. To decrease volume, press [d].
• There are 8 volume levels. If you try to increase/decrease volume when it is at the
maximum/minimum level, the base unit beeps 3 times. The level is displayed on
the base unit.
1 Press [SP-PHONE].
• The SP-PHONE indicator lights.
• A free line is automatically selected
and the line button lights. (To change
the line selection, see page 71.)
• You can select a line by pressing a
line button that does not light, instead
of pressing [SP-PHONE].
2 Dial a phone number.
• If you misdial, press [SP-PHONE]
and start again from step 1.
3 When the other party answers,
speak into the MIC (microphone).
4 To hang up, press [SP-PHONE].
• The SP-PHONE indicator and line
button lights go out.
Hands-free Digital Duplex Speakerphone
For best performance, please note the following:
• Speak alternately with the other party in a quiet room.
• If you or the other party has difficulty hearing, press [d] to decrease the
speaker volume.
SELECT
SAVE
Base Unit
[REDIAL/PAUSE]
[B], [d]
[HOLD]
MIC
[SP-PHONE] and Indicator
LINE Buttons
LINE1 LINE2
TG6500C_CordlessTel1.fm Page 39 Thursday, September 30, 2004 4:56 PM
To Next Page
Loading...
