Direct Commands
90
During programming:
When “ ” or “ ” is displayed, press the right soft key to save the new
settings.
To exit programming, press [OFF].
• If you press the direct command incorrectly, press [OFF], then re-enter
programming mode by pressing [MENU].
• For function details, see the corresponding pages.
Recording mode [0] [6] [4] [1] : Standard recording
(60 min)
[2] : Enhanced recording
(30 min)
p. 34
Display language [0] [8] [1] [1] : English [2] : French p. 20
Voice guidance language [0] [8] [2] [1] : English [2] : French p. 21
Room monitor
(Handset)
[0] [9] [1] : On [0] : Off p. 64
Message alert [0] [#] [1] : On [0] : Off p. 34
Ringer tone
(Base unit)
Line 1 [0] [*] [1] [1] [1]–[4] : Tone pattern 1–4
[5]–[8] : Melody pattern 1–4
p. 29
Line 2 [0] [*] [1] [2]
Incoming call tone
(Base unit)
[0] [*] [2] [1] : On [2] : 2 times
[0] : Off
p. 69
Room monitor (Base unit) [0] [*] [3] [1] : On [0] : Off p. 64
Line selection
(Base unit)
[0] [*] [5] [0]
: Auto
[1]
: Line 1
[2]
: Line 2
p. 71
Ringer volume
(Base unit)
Line 1 [0] [*] [6] [1] [1] : Low [2] : Medium
[3] : High [0] : Off
p. 27
Line 2 [0] [*] [6] [2]
Handset registration [0] [0] [1] Go to Step 5 on page 92. –
Handset deregistration [0] [0] [2] [3] [3] [5] p. 91
Phone book [*] To store an item, go to Step
2 on page 48.
To search for items, go to
Step 2 on page 50.
–
Menu item Command Selection items Page
SAVE
OK
TG6500C_Usefulinfo.fm Page 90 Thursday, September 30, 2004 4:58 PM
To Next Page
Loading...
