128
Recording
∫ Setting the light source
You can change the position and size of the light source.
1 Touch [ ].
2 Touch [ ] to display the setting screen.
•
You can also display the setting screen by pressing [Fn3].
3 Touch the location where you want to place the
center of the light source.
•
The position of the light source can also be moved with the
cursor button.
• The center of the light source can be moved to the edge of
the screen.
4 Pinch out/pinch in (P17) to adjust the size of the light
source.
•
It can be changed to 4 different sizes.
• Enlarge/reduce can also be performed by rotating the rear
dial.
• Touching [Reset] returns the light source setting to the
default setting.
5 Touch [Set].
• Display of the recording screen will be delayed more than usual and the screen will look as if
frames are dropping.
Point for when placing the center of the light source
A more natural appearance can be created by placing the center of the light source
outside the image.
DMC-G6PDF-VQT4Z78_eng.book 128 ページ ２０１３年４月２５日 木曜日 午前１０時５分
To Next Page
Loading...
