288
Wi-Fi/NFC
[Wi-Fi Setup] Menu
Configure the settings required for the Wi-Fi function.
[Wi-Fi Setup] cannot be changed when connected to Wi-Fi. (excluding [Network Address])
Select the menu.
•
Refer to P274 for details.
• For details on how to enter characters, refer to “Entering Text” section on P64.
• If you are using the PC with standard settings, you do not need to change the workgroup.
• For details on how to enter characters, refer to “Entering Text” section on P64.
• A maximum of 32 characters can be entered.
• Refer to P279 for details.
[MENU] > [Setup]>[Wi-Fi]>[Wi-Fi Setup]>Desired item to be set
[LUMIX CLUB]
Acquires or changes the “LUMIX CLUB” login ID.
[PC Connection]
You can set the workgroup.
To send images to a PC, a connection to the same workgroup as
the destination PC is required.
(The default setting is “WORKGROUP”.)
[Change Workgroup Name]:
Enter the workgroup of the connecting PC.
Exit the menu after it is set.
[Restore to Default]:
Restores the default state.
Confirmation screen is displayed. It is executed when [Yes] is
selected.
Exit the menu after it is executed.
[Device Name]
You can change the name of this unit.
1 Press [DISP.].
2 Enter the desired device name.
[External AV device]
Images can be sent to the AV device of relatives and
acquaintances via “LUMIX CLUB”.
[NFC Operation]
Configures the settings for the NFC function.
[ON]:
NFC function is worked.
[OFF]
DMC-G6PDF-VQT4Z78_eng.book 288 ページ ２０１３年４月２５日 木曜日 午前１０時５分
To Next Page
Loading...
