146
Recording
Applicable modes:
By using flashes that support the wireless control (DMW-FL360L: optional), you can
control firing of the built-in flash (or a flash attached to the hot shoe of this unit) and three
flash groups separately.
1 Set the external flashes to be controlled to RC Mode, and then place them.
•
Set the channel and groups for the external flashes to be controlled.
2 Select [Flash] on the [Rec] menu. (P43)
3 Select [Wireless] and then touch [ON].
•
When [Wireless] is set to [ON], [WL] is displayed on the flash icon on the recording
screen.
• When making detailed settings of the wireless flash, set the following from [Flash].
[Wireless Channel]
Select the channel that corresponds to the channel of the external flash you want to
control.
Settings: [1CH]/[2CH]/[3CH]/[4CH]
[Wireless FP]
During wireless recording, an external flash fires an FP flash (high speed repetition of flash
firing). This firing allows recording with the flash at a fast shutter speed.
Settings: [ON]/[OFF]
[Communication Light]
Set the communication light level for wireless recording.
Settings: [HIGH]/[STANDARD]/[LOW]
[Wireless Setup]
•
Press the [DISP.] button to fire a test-flash.
A Firing Mode
B Flash output
C Luminosity ratio
Setting the wireless flash
Preparations: Open the flash of this unit by pressing flash open button.
Alternatively, attach a flash (DMW-FL360L: optional) to this unit.
DMC-G6PDF-VQT4Z78_eng.book 146 ページ ２０１３年４月２５日 木曜日 午前１０時５分
To Next Page
Loading...
