183
Recording
∫ Canceling the Auto Bracket
Select [ ] (single picture recording) or [ ] from among the drive modes.
(P178)
∫ Changing the settings for [Single/Burst Settings], [Step] and [Sequence] in Auto
Bracket
1 Select [Auto Bracket] in the [Rec] menu. (P43)
2 Touch [Single/Burst Settings], [Step] or [Sequence].
3 Touch the setting.
•
You can take one picture at a time when set to [ ].
• You can continuously take pictures up to set numbers when set to [ ].
• Exit the menu after it is set.
• When taking pictures using Auto Bracket after setting the Exposure Compensation range, the
pictures taken are based on the selected Exposure Compensation range.
Not available in these cases:
•
The exposure may be compensated incorrectly, depending on the brightness of the subject.
• Auto Bracket is disabled in the following cases.
– [Glistening Water]/[Glittering Illuminations]/[Soft Image of a Flower] (Scene Guide Mode)
– [Miniature Effect]/[Soft Focus]/[Star Filter]/[Sunshine] (Creative Control Mode)
– When White Balance Bracket is set.
– When recording motion pictures
– When recording using the flash
– When [HDR] is set to [ON]
– [Multi Exp.]
– When using [Time Lapse Shot]
– In [Stop Motion Animation] (only when [Auto Shooting] is set)
Item
Settings
Item
Settings
[Single/Burst
Settings]
[ ] (single)
[Sequence]
[0/`/_]
[] (burst) [`/0/_]
[Step]
[3•1/3] (3 pictures)
[3•2/3] (3 pictures)
[3•1] (3 pictures)
[5•1/3] (5 pictures)
[5•2/3] (5 pictures)
[5•1] (5 pictures)
[7•1/3] (7 pictures)
[7•2/3] (7 pictures)
[7•1] (7 pictures)
DMC-G6PDF-VQT4Z78_eng.book 183 ページ ２０１３年４月２５日 木曜日 午前１０時５分
To Next Page
Loading...
