185
Recording
4
Press the shutter button halfway to focus and
then press it fully to take the picture.
• A picture is not taken until the subject is brought into
focus. Focus and exposure will be set when the shutter
button is pressed halfway.
• If you want to press the shutter button fully to take a
picture even when the subject is not focused, set [Focus/Release Priority] in the
[Custom] menu to [RELEASE]. (P170)
• The self-timer indicator A blinks and the shutter is
activated after 10 seconds (or 2 seconds).
• When [ ] is selected, the self-timer indicator blinks
again after the first and the second pictures are taken and
the shutter is activated 2 seconds after it blinks.
∫ Canceling the self-timer
Select [ ] (single picture recording) or [ ] from among the drive modes.
(P178)
•
It is also possible to cancel by turning off this unit.
• Time setting for the self timer can also be set by [Self Timer] in the [Rec] menu.
• Depending on the recording conditions, the recording interval may become more than
2 seconds when [ ] is selected.
• The flash output may vary slightly when the [ ] is selected.
Not available in these cases:
•
It cannot be set to [ ] in the following conditions.
– When White Balance Bracket is set
– [Multi Exp.]
• Self-timer is disabled in the following cases.
– When recording motion pictures
– When using [Time Lapse Shot]
– In [Stop Motion Animation] (only when [Auto Shooting] is set)
Canceling/not canceling the self-timer when this unit is turned off
[MENU] > [Custom]>[Self Timer Auto Off]>[ON]/[OFF]
•
At the time of purchase, this is set to [ON], so the self-timer will be canceled if this unit is
turned off.
• We recommend using a tripod when recording with the self-timer.
DMC-G6PDF-VQT4Z78_eng.book 185 ページ ２０１３年４月２５日 木曜日 午前１０時５分
To Next Page
Loading...
