Starting to use
Turning on the power
Please ensure that all preparations have been completed before turning on
the power. (Refer to pages 18 - 21 .)
Remove the lens cover.
Connect the accessory mains lead.
Press the MAIN POWER switch to
the "l'" side to turn on the power.
The power indicator on the projector
will illuminate red.
Press the POWER button.
The power indicator on the projector
will flash green. After a short period,
the button will illuminate green, and a
picture will be projected.
Press the INPUT select button to
select the input signal.
The input signal setected wilt change O__O_ iiiias shown at below-right each time an
input select button (INPUT/VIDEO/ O Q !!!!
CMPNT/PC/SD) is pressed.
L_
While pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector.
If there is keystone distortion in the
projected images, carry out keystone
correction as described on page 28.
22-ENGLISH
To Next Page
Loading...
