Adjusting the position
When the input signal is from a
PC, first select AUTO SETUP and
then press the ENTER button to
initiate automatic positioning.
If the optimum setting is not
obtained when AUTO SETUP is
carried out, adjust by the following
procedure.
Use the • and • buttons to select
an item, and then use the • and •
buttons to change the setting for
that item.
For items with bar scales, press the
ENTER button or the • or •
buttons to display the adjustment
screen, and then use the • or •
buttons to make the adjustment.
When an S-VIDEO/VIDEO/AV1/
YPBPR/DVI signal is being input or
SD CARD is selected.
ASPECT POSITION16 : 9
V-POSITION O
# SELECT []_NTER _C
• "ASPECT" can be adjusted only
when a DVI signal is being input
or when "SD CARD" is selected.
When an PC signal is being input
ASPECT POSITIIN4 : 3
V-POSITION 0 ==_
DOT CLOCK 0 ==_
CLOCK PHASE 0 =_
IAUTO SETUP I
# SELECT _NTER _C
VERTICAL POSITION
(S-VIDEO/VIDEO/YPsPPJPC/AV 1
only)
Press the • button to move the
picture down, and press the •
button to move the picture up.
DOT CLOCK
(PC only)
Periodic striped pattern interference
(noise) may occur when a striped
pattern such as the one below is
projected. If this happens, use the
• and • buttons to adjust so that
any such noise is minimised.
CLOCK PHASE
(PC only)
Adjust the DOT CLOCK setting first
before carrying out this adjustment.
Use the • and • buttons to adjust
so that the noise level is least
noticeable.
NOTE:
• If signals with a dot clock
frequency of 100 MHz or higher
are being input, interference may
not be completely eliminated
when the DOT CLOCK and
CLOCK PHASE adjustments are
carried out.
HORIZONTAL POSITION
(S-VIDEO/VIDEO/YPsPPJPC/AV 1
only)
Press the • button to move the
picture to the left, and press the •
button to move the picture to the
right.
38-ENGLISH
To Next Page
Loading...
