Before asking for service
Before asking for service, check the following points.
Problem Possible cause
Power does not • The power cord may not be connected.
turn on. • The MAIN POWER switch is turned off.
• The main power supply is not being supplied to the
watt outlet.
• TEMP indicator is illuminated or flashing. (Refer to
page 51.)
• LAMP indicator is illuminated or flashing. (Refer to
page 52.)
• The lamp unit cover has not been securely
installed.
No picture appears. • The video signal input source may not be
connected properly.
• The input selection setting may not be correct.
(Refer to page 22.)
• The BRIGHT adjustment setting may be at the
minimum possible setting. (Refer to page 34.)
• The shutter function may be in use. (Refer to page
33.)
The picture is • The lens cover may still be attached to the lens.
fuzzy. • The tens focus may not have been set correctly.
(Refer to page 23.)
• The projector may not be at the correct distance
from the screen. (Refer to page 21.)
• The lens may be dirty.
• The projector may be tilted too much. (Refer to
page 23.)
COLOUR istoo light • COLOUR or TINT adjustment may be incorrect.
or TINT is poor (Refer to pages 34 and 35.)
• The input source which is connected to the
projector may not be adjusted correctly.
No sound can be • The audio signal source may not be connected
heard, properly.
• The volume adjustment may be at the lowest
possible setting. (Refer to page 15.)
• Make sure that the MUTE function is not activated.
(Refer to page 33.)
ENGLISH-57
To Next Page
Loading...
