Problem
Remote control unit
does not operate.
]'he picture does not
display correctly.
Picture from
computer does not
appear
Possible cause
• The battery may be weak.
• The battery may not be inserted correctly. (Refer to
page 17.)
• The remote control signal receptor on the projector
may be obstructed. (Refer to page 17.)
• The remote control unit may be out of the
operation range. (Refer to page 17.)
• The correct input signal may not be selected.
(Refer to page 22.)
• The signal format (TV system) may not be set
correctly. (Refer to page 35.)
• There may be a problem with the video tape or
other signal source.
• A signal which is not compatible with the projector
may be being input. (Refer to page 61 .)
• The cable may be too long.
• The external video output for the laptop computer
may not be set correctly.
(You may be able to change the external output
settings by pressing the [Fn]+[F3] or [Fn]+[F10]
keys simultaneously. The actual method varies
depending on the type of computer, so refer to the
documentation provided with your computer for
further details.)
58-ENGL/SH
To Next Page
Loading...
