<_Turn the focus/zoom ring to adjust
the projected image focus and size.
Zoom =
_OCUS "
Turning off the power
Press the POWER button. "POWER OFF" is
displayed on the screen. POWER OFF
_Select "OK" using the <1and • buttons and
press the ENTER button.
The lamp unit willswitch off and the picture willstop being projected. (The
power indicator on the projector will illuminate orange.)
<_ Wait until the power indicator on the projector illuminates red (until
the cooling fan stops).
Do not in any way cut power to the projector while the cooling fan is still
operating. Be careful not to switch off the MAIN POWER switch of the
projector, unplug the mains lead from the electrical outlet or turn off in-line
switches such as tabletop power switches.
_> Press the MAIN POWER switch to the "0" side to turn off the power.
NOTE:
• After the power is turned off, the lamp unit will take some time to cool
down. If you turn the power back on again before the lamp unit has cooled
down, the lamp unit may not turn on straight away, but itwill turn on
automatically after a short period. (During this time, the power indicator on
the projector willflash orange.)
• When the projector is in standby mode (the power indicator on the
projector is illuminated red), the projector will still draw a maximum 1.5 W
of power, even when the cooling fan has stopped.
• If the MAIN POWER switch is accidentally turned offwhile the projector is
being used, the lamp unit may not turn on straight away after the power is
turned back on. In such cases, the lamp unit will turn back on
automatically after a short period. (During this time, the power indicator on
the projector willflash green.)
• A tinkling sound may be heard while the power indicator is turned off, but
this is not a sign of a malfunction.
• You can also turn off the power by pressing the POWER button twice or
by holding down it for at least 0.5 seconds.
ENGLISH-23
To Next Page
Loading...
