4:3 H-POS
(4:3 aspect mode only)
i#. : 3 H--POS 4 CENTRE _'i_l
$
J
14 RIGHT _1
€
14 LEFT IJl
This sets the horizontal positioning
of the projected image when the 4:3
aspect ratio is selected. (Refer to
page 31.)
FRONT/REAR
IFRONT/REAR 4 FRO_T _'l]
14 REAR )'1
This setting should be changed in
accordance with the projector
setting-up method.
Set to "FRONT" when using a
normal reflective screen with the
projector positioned in front of the
screen, and set to "REAR" when
using a translucent screen with the
projector positioned behind the
screen.
DESK/CEILING
IDESK/OEILING 4 DESK$ iI'I_I
I4OEILING I
This setting should be changed in
accordance with the projector
setting-up method.
Set to "DESK" when setting up the
projector on a desk or similar, and
set to "CEILING" when suspending
the projector from the ceiling using
the ceiling bracket which is sold
separately.
FAN CONTROL
elevations (above 1 400 m), set
FAN CONTROL to "HIGH".
LAMP POWER
IL ArlP POWER 4 HIGH *I_
$
I
14 LOW I'1
This setting changes the lamp
brightness. When set to "LOW", the
luminance of the lamp is reduced,
but the projector uses less power,
and the operating noise is also
reduced.
The LOW position is recommended
for narrow rooms where a high
picture luminance is not essential or
for watching movies.
LAMP RUNTIME
This setting displays the usage time
for the lamp unit which is currently
being used.
NOTE:
• The lamp's operating life varies
depending on the usage
conditions (such as the LAMP
POWER setting and the number
of times the power is turned on
and off).
IFANCONTROL 4NORMALI4HIGH_' ))_
If using of this projector at high
40-ENGLISH
To Next Page
Loading...
