Chapter 4 Settings — [SIGNAL LIST] menu
[SIGNAL LIST] menu
Refer to x for the operation of the menu screen.
r Registered signal details
A1 (1-2)
When the address number (A1, A2, ... L7, L8) signal is registered
Sub memory number
Memory number:
f (x page 103).
Registering new signals
[MAIN MENU] screen is displayed.
Note
f
f
f The names to be registered are automatically determined by the input signals and memory numbers.
f
Renaming the registered signal
Registered signals can be renamed.
1) Press asqw
f The [REGISTERED SIGNAL STATUS] screen is displayed.
f The memory number, input terminal, input signal name, frequency, synch polarity, etc., are displayed.
f [SIGNAL LIST] screen.
3)
f The [REGISTERED SIGNAL SETUP] screen is displayed.
4) Press as to select [SIGNAL NAME CHANGE].
f The [SIGNAL NAME CHANGE] screen is displayed.
6) Press asqw
7) asqw
f The registration is completed and the [REGISTERED SIGNAL SETUP] screen returns.
f When pressing asqw
an automatically registered signal name will be used.
Expanding signal lock-in range
1) Press asqw to select the signal to set.
f The [REGISTERED SIGNAL STATUS] screen is displayed.
To Next Page
