Chapter 4 Settings — [ADVANCED MENU] menu
Blanking correction Item Operation Adjustment Range of adjustment
Left side of the
screen
[LEFT]
Press the w
button.
The blanking zone
moves to the right.
PT-EW640
Press the q
button.
The blanking zone
moves to the left.
Right side of the
screen
[RIGHT]
Press the q
button.
The blanking zone
moves to the right.
Press the w
button.
The blanking zone
moves to the left.
[INPUT RESOLUTION]
1) Press as to select [INPUT RESOLUTION].
f The [INPUT RESOLUTION] screen is displayed.
3) Press as
qw to adjust each item.
f
and adjust to the optimal point viewing the screen when there are vertical stripes or sections are missing from the screen.
Note
f Previously mentioned vertical banding will not occur with all white signal input.
f
f
[CLAMP POSITION]
You can adjust the optimal point when the black part of the image is blunt or it has turned green.
1) Press as to select [CLAMP POSITION].
Press qw to adjust.
Status Rough guide for optimal value Range of adjustment
The point where bluntness of the black part improves the most is
the optimal value.
The point where the green part becomes black, and the bluntness
has improved is the optimal value.
Note
f
f
[RASTER POSITION]
This will allow the position of the image to move within the display area arbitrarily when the input image is not using the whole display area.
1) Press as to select [RASTER POSITION].
f The [RASTER POSITION] screen is displayed.
3) Press asqw to adjust the position.
To Next Page
Loading...
