Chapter 4 Settings — [PROJECTOR SETUP] menu
[NUMBER OF REGISTERED
SIGNAL]
[SIGNAL INFORMATION]
[MEMORY NO.]
[INPUT]
[SIGNAL NAME]
[SIGNAL FREQUENCY]
[SYNC.STATE]
[V.SYNC WIDTH]
[SCAN TYPE]
[TOTAL DOTS]
[DISPLAY DOTS]
[TOTAL LINES]
[DISPLAY LINES]
[SAMPLING]
[SIGNAL LEVEL]
*1 The lamp runtime displayed is calculated internally by the following conversions.
Formula for lamp replacement time (rough estimate)
Lamp runtime displayed in
[LAMP : TOTAL]
(AB
f A
f B
*2
Note
f [STATUS] screen.
f
[DATE AND TIME]
Setting the time zone
1) Press as to select [DATE AND TIME].
f The [DATE AND TIME] screen is displayed.
3) Press as to select [TIME ZONE].
4) Press qw to switch [TIME ZONE].
Setting the date and time manually
1) Press as to select [DATE AND TIME].
f The [DATE AND TIME] screen is displayed.
3) Press as to select [ADJUST CLOCK].
4)
f The [ADJUST CLOCK] screen is displayed.
Press asqw to set the local date and time.
6) Press as
f The setting of the date and time will be completed.
Setting the date and time automatically
1) Press as to select [DATE AND TIME].
To Next Page
Loading...
