Chapter 4 Settings — [DISPLAY OPTION] menu
[WIDE]
settings.
[USER]
f 7).
f .
Press asqw to adjust [DISPLAY DOTS] to the horizontal
resolution of the signal source.
6) Press as to select [MODE].
7)
f
[AUTO SETUP] screen.
Adjusting position automatically
1) Press as to select [AUTO SETUP].
f The [AUTO SETUP] screen is displayed.
3) Press as to select [POSITION ADJUST].
4) Press qw to switch the item.
[ON]
[OFF]
Adjusting signal level automatically
1) Press as to select [AUTO SETUP].
f The [AUTO SETUP] screen is displayed.
3) Press as to select [SIGNAL LEVEL ADJUST].
4) Press qw to switch the item.
[OFF]
[ON]
Note
f
[RGB IN]
Switching the slice level of an input sync signal
1) Press as to select [RGB IN].
f The [RGB IN] screen is displayed.
3) Press as
4) Press qw to switch the item.
[LOW]
[HIGH]
To Next Page
Loading...
