Chapter 4 Settings — [DISPLAY OPTION] menu
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [SHUT-OFF].
4) Press qw to switch the item.
[KEEP CURRENT STATE]
When the projector is switched off, the projector turns into standby with the shutter status as is.
[OPEN]
When the projector is switched off, the projector turns into standby with the shutter left opened.
[CLOSE]
When the projector is switched off, the projector turns into standby with the shutter left closed.
[P-TIMER]
Setting the mode
1) Press as to select [P-TIMER].
f The [P-TIMER] screen is displayed.
3) Press as to select [MODE].
4) Press qw to switch the item.
[COUNT UP]
[COUNT DOWN]
Setting the timer
1) Press as to select [P-TIMER].
f The [P-TIMER] screen is displayed.
3) Press as to select [TIMER].
4) Press qw to set the time.
f The time can be set in 1-minute increments from 1 to 180 minutes.
f The factory default value is 10 minutes.
Note
f
Using the presentation timer
1) Press as to select [P-TIMER].
f The [P-TIMER] screen is displayed.
3) Press as
[START]
The count is started.
[STOP]
The count is stopped.
[RESTART]
The count is resumed.
[RESET]
The count is reset.
f
image.
f
projected image.
f 4).
To Next Page
Loading...
