Panasonic PT-FRZ50

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 105
[COMPUTER2]
Sets the input to COMPUTER2.
[VIDEO]
Sets the input to VIDEO.
[HDMI1]
Sets the input to HDMI1.
[HDMI2]
Sets the input to HDMI2.
[DIGITAL LINK]
Sets the input to DIGITAL LINK.
[INPUT1] - [INPUT10]
*1
Sets the input to DIGITAL LINK, and switches the input of the Panasonic twisted-pair-cable transmitter
to the specied input.
*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reected from [INPUT1] to [INPUT10]. When an item that does not reect the input name is selected, it will be disabled.
[RS-232C]
Set the communication condition of the <SERIAL IN> terminal. Refer to “<SERIAL IN> terminal” (
x
page 172).
1) Press
as
to select [RS-232C].
2) Press the <ENTER> button.
f
The
[RS-232C]
screen is displayed.
3) Press
as
to select [INPUT SELECT].
4) Press
qw
to switch the item.
[PROJECTOR]
Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
[DIGITAL LINK]
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
5) Press
as
to select [BAUDRATE].
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[9600]
Select the proper speed.
[19200]
[38400]
7) Press
as
to select [PARITY].
8) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NONE]
Select the parity condition.
[EVEN]
[ODD]
Note
f
When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f
When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for “NO
SIGNAL SLEEP” of the DIGITAL LINK output supported device should be set to “OFF” to avoid interruption of communication.
f
The input communication speed is xed to 9 600 bps when [INPUT SELECT] is set to [DIGITAL LINK].
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press
as
to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f
The
[FUNCTION BUTTON]
screen is displayed.
3) Press
as
to select a function.
[DISABLE]
Disables the <FUNCTION> button.
[SUB MEMORY]
Displays the sub memory list. (
x
page 116)