Panasonic PT-FRZ50 - About the Link Control

Chapter 5 Operations — Using HDMI-CEC function
ENGLISH - 151
Menu operation of CEC-compatible device
When the setting menu of the CEC-compatible device is displayed, you can use the ▲▼◀▶ buttons and
<ENTER> button of the remote control to operate the menu.
About the link control
By setting the [PROJECTOR SETUP] menu → [HDMI CEC] → [PROJECTOR -> DEVICE] / [DEVICE ->
PROJECTOR] to a setting other than [DISABLE], the following link operations can be achieved.
The link control setting of [PROJECTOR -> DEVICE]
r
When the setting is [POWER OFF] or [POWER ON / OFF]
f
If the projector is switched o󰀨, all connected CEC-compatible devices are switched o󰀨.
r
When the setting is [POWER ON / OFF]
f
If the input channel is HDMI1 or HDMI2 when the projector is switched on and starts projection, then the CEC-
compatible devices connected to the <HDMI 1 IN> terminal or <HDMI 2 IN> terminal are switched on upon
startup of the projector.
f
When you switch the input to HDMI1 or HDMI2, the CEC-compatible devices connected to the <HDMI 1 IN>
terminal or <HDMI 2 IN> terminal are switched on.
The link control setting of [DEVICE -> PROJECTOR]
r
When the setting is [POWER ON] or [POWER ON / OFF]
f
When the CEC-compatible device switches on, the projector switches on and switches the input to which the
CEC-compatible device is connected.
f
When the CEC-compatible device starts playing, the projector switches on and switches the input to which the
CEC-compatible device is connected.
f
When the CEC-compatible device starts playing, the projector switches the input to which the CEC-compatible
device is connected.
r
When the setting is [POWER ON / OFF]
f
When the CEC-compatible device connected to the selected input (HDMI1 or HDMI2) is switched o󰀨, the
projector enters standby mode.
Note
f
Depending on the status of the device, such as when the projector or the CEC-compatible device is starting up, the link control may not
operate normally.
f
If the CEC-compatible device does not support CEC 1.4, it may not support the link control described in the manual.