Panasonic PT-FRZ50

Chapter 6 Maintenance — Light source/temperature indicators
158 - ENGLISH
Light source/temperature indicators
When an indicator lights up
If a problem occurs inside the projector, the light source indicator <LIGHT> or the temperature indicator <TEMP>
will inform you by lighting or blinking. Check the status of the indicators and take following measures.
Attention
f
When switching o󰀨 the projector to deal with problems, make sure to follow the procedure in “Switching o󰀨 the projector” (
x
page 46).
Light source indicator <LIGHT>
Temperature indicator <TEMP>
Light source indicator <LIGHT>
Indicator status
Lighting red
Blinking red
(2 times)
Blinking red
(3 times)
Status
Some of the elements of the light
source are defective and the light
output has decreased.
The light source does not light up, or the light source turns o󰀨 while the
projector is in use.
Cause
―
Solution
f
Turn the <MAIN POWER> switch to <OFF> (
x
page 46), and turn on the power again.
Note
f
If the light source indicator <LIGHT> continues to light or blink even after the measure is taken, set the <MAIN POWER> switch to <OFF>,
and ask your dealer for repair.
f
The light source indicator <LIGHT> lights green while the projector is in projection mode if there is no notication by lighting or blinking red.