Panasonic PT-FRZ50

Chapter 7 Appendix — Technical information
172 - ENGLISH
Communication ow between server and client
To send/receive a command via LAN, refer to the communication ow indicated below.
Server
: Projector
Client
: Control device such as a computer
Connection request
Server
Client
Sending of key
Sending of command 1
Responding to command 1
Disconnection
Connection request
Sending of key
Sending of command 2
Responding to command 2
Disconnection
Session 1
Session 2
<SERIAL IN> terminal
The <SERIAL IN> terminal of the projector conforms with RS-232C so that the projector can be connected to and
controlled from a computer.
Connection
When connecting directly
Projector connecting terminals
Computer
D-Sub 9p (male)
Communication cable (straight)
D-Sub 9p (female)
When connecting using DIGITAL LINK compatible device
DIGITAL LINK compatible device
Computer
D-Sub 9p (female)
Projector connecting terminals
DIGITAL LINK DIGITAL LINK
D-Sub 9p (male)
Communication cable (straight)
LAN cable (straight)
Note
f
The destination of [RS-232C] (
x
page 105) must be set according to the connection method.
f
When connecting using a DIGITAL LINK compatible device, set the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[STANDBY
MODE] to [NORMAL] to control the projector in the standby mode.
When [STANDBY MODE] is set to [ECO], the projector cannot be control during standby.