115
1. After attaching the infrared receiver to the decorative panel, route the receiver’s joint cord as shown in the
diagram below and pass the cord through the hook located on the rear side of the decorative panel so it does not
stick out.
2. Remove the control box cover by removing the two screws and connect joint cord for wiring to the P.C.B
connector <CN-DISP> in the control box.
Note
When securing the decorative panel to the unit, be sure that the receiver’s joint cord remains inside the decorative
panel and is not caught on the ceiling.
Joint cord for receiver remains
inside the decorative panel.
Ceiling
Decorative panel
Indoor unit
To Next Page
Loading...
