205
Accessories
Check that you have the following accessories.
Name Q’ty Diagram Remark
Cooling/Heating selector SW 1
CZ-RD1
HEAT
MODE
FAN
COOL
For setting the cooling/heating operation
Installation manual 1
This manual
11.17.1 EXTERNAL DIMENSIONS
(Unit: mm)
CZ-RD1
HEA T
MOD E
FAN
COO L
120
70
61
68
11.17.2 CONNECTION PROCEDURE
Be sure to always turn the power off before proceeding with wire and cable set up.
Failure to do so may lead to electric shock or fire.
• Connecting cable to H05RN-F or H07RN-F which conforms to CENELEC (HAR) rating specifications, or use the
cables based on IEC standard. (245IEC57, 245IEC66) Diameter: 0.5 mm
2
.
• The maximum wire/cable length is 150 meters. Also avoid installing near power cable due to possible malfunction.
1. Removing the decorative panel.
The decorative panel is embedded in the unit.
Remove the decorative panel from the mount.
You can separate the decorative panel from
mount quite easily at the points where it clips in.
2. Remove the case.
Remove the screws (2 pcs.) that secure the case.
3. Connect the wiring.
Connect the electric wiring (Local supply) to the
round terminals of the short wires and then
crimped.
Mount
Case
Decorative panel
To Next Page
Loading...
