141
SETTING OUTDOOR UNIT ADDRESS
• Setting and clearing the outdoor unit address on the indoor unit can be performed.
• It is possible to set the address value from “001” to “199”. Setting the address to “000” clears it.
• Set the mode number to “06” and choose a setting value from “000” to “199” according to the local setting
procedure.
LOW SOUND SETTING
• Press the SET
switch
○
2 to operate the “Local setting mode”.
• Use the
switches TEMP to choose “02” for the “Mode No.”
• Use the
switches TIMER to choose from “001”, “002” or “003” for the “Setting value”.
• Press the SELECT
switch and use the switches TIMER to set the night time low noise “end” time.
Press the SET
switch
○
1 to confirm.
• After the “end” time is set, the display proceeds to the “start” time setting. Use the
switches TIMER to adjust
the time and the SET
switch
○
1 to fix the “start” time setting. After the “start” time is displayed for approximately
2 seconds, it exits from local setting mode.
Note
* Be sure to always set the current time with the infrared remote controller.
(Refer to the operation instruction for the current time setting method.)
* For ventilation control, select the mode number and corresponding setting in the table according to the local setting
procedure.
To Next Page
Loading...
