191
2. Connect the lead wires from the installed terminal module with the connection points found on the upper part of
the noise filter P.C.B.
Connect 10P to CN-OPT1, 2P to CN-OPT2 and 4P to CN-OPT3.
3. Use the cord provided for P.C.B to connect to CN-OPT4 on the main P.C.B and to CN-OPT4 on the noise filter
P.C.B.
Cord for connecting the P.C.B
CN-OPT4
Main P.C.B
CN-OPT4
4. Secure the cord clamp provided to the holes located on the right side of control panel.
To Next Page
Loading...
