202
11.16.2 WIRING PROCEDURE
Follow the wiring procedure below for terminal connection.
○
1
Set up the wiring through the back side of the control panel.
○
2
Secure the wiring with the cord clamp located on the right side of the control panel.
○
3
Set the wiring and cables for the power and signal lines to the outdoor unit together, and secure each wire and
cable with the tie.
○
4
Secure and clamp the power and signal lines with the tie, set up close to the 3 way valve.
○
5
Set up the wiring and cable for the outdoor unit piping and secure with a tie.
To Next Page
Loading...
