33
TH-103PF12E
1. Remove the Side Angle (R).
(Refer to Removal of the Side Angle (R))
2. Remove 3 screws ( ).
3. Remove 3 screws ( ) and then remove the Reinforce-
ment Angle (lower_right).
4. Disconnect the Fan relay connectors.
5. Remove 2 screws and then remove the Fan Block (1).
6. Remove 1 screw ( ).
7. Remove 4 screws ( ) and then remove the Side M16
Block.
8. Remove the flexible cables from the connectors (SD1,
SD2, SD3, SD4, SD12).
9. Disconnect the connector (SD44).
10. Remove 5 screws ( ).
11. Remove 3 screws ( ) and then remove SD-Board.
9.19. Removal of SC-Board
To Next Page
Loading...
