41
TH-103PF12E
1. Remove the Reinforcement Angle (lower_center).
(Refer to Removal of C3-Board (lower))
2. Remove the flexible cables from the connectors (C40,
C41, C42).
3. Remove 6 screws ( ) and then remove the flexible
cables from the connectors (CA9, CA10, CA11).
4. Remove 6 screws ( ) and then remove C4-Board (lower).
9.34. Removal of C5-Board (lower)
1. Remove the Reinforcement Angle (lower_right).
(Refer to Removal of SD-Board)
2. Disconnect the connector (C55).
3. Remove the flexible cables from the connectors (C50,
C51).
4. Remove 6 screws ( ) and then remove the flexible
cables from the connectors (CA12, CA13, CA14).
5. Remove 6 screws ( ) and then remove C5-Board (lower).
9.35. Removal of C6-Board (lower)
1. Remove the Reinforcement Angle (lower_right).
(Refer to Removal of SD-Board)
2. Remove the flexible cable from the connector (C61).
3. Remove 4 screws ( ) and then remove the flexible
cables from the connectors (CA15, CA16).
4. Remove 4 screws ( ) and then remove C6-Board (lower).
9.36. Removal of AC Inlet
To Next Page
Loading...
