Section 700 - Operation Chapter 6. SLT Features
DBS-2.3/9.2-700 DBS Manual - Revised April 2000 6-21
To add an outside number (CPC-AII and CPC-B Version 3.1 or
higher):
1. Flash the switchhook to place the current call on hold.
2. Dial a trunk group number (81-86 or 9).
3. Dial the outside number.
4. Flash the switchhook when your call is answered.
Related Programming
• FF3 (Extension): Single Line Telephone Hookflash (Brokers Hold/
Conference)
Considerations
• Call Waiting tone can be received during conference calls, however, you
cannot respond to call waiting until the completion of the conference call
because you cannot place the parties in the conference on hold.
• A switchhook flash is ignored during a conference call.
• Calls forwarded externally cannot create a conference.
• The Hold feature cannot be used during a three-party conference.
Dial “0” for Attendant
(CPC-AII and CPC-B Version 2.0 or higher)
Description
Users can call the Attendant from any extension by pressing “0.”
If multiple attendants are assigned, a dial “0” call goes to Attendant “1” first.
If attendant “1” is busy, the call goes to Attendant “2.” The call continues to
transfer to the next attendant in the attendant group if necessary.
A maximum of four attendants can be assigned.
Operation
1. Lift the handset.
To Next Page
Loading...
