Appendix A. EX 1.0 Feature Update Section 700-Operation
Page A-14 DBS Manual - Revised April 2000 DBS-2.3/9.2-700
ExtPort# 29#); during a trunk call (FF3 ExtPort# 30#); and
after dialing a busy extension (FF3 ExtPort# 33#).
• Use existing addresses FF1 2# 7# 1# thru 4# to assign select
key features to Flexible Function Screens.
• Use existing addresses FF1 2# 7# 2# to assign screen text.
• Select key features for Fixed Function Screens will not
appear on small-display phones.
3. While the select key feature is displayed, you can execute the
feature by pressing the > or < select key.
Notes
Toggling Variable Mode On/Off with an FF-Key.
You can program the
*61
code into an FF-key: In programming mode, press FF5 (ExtPort)#
(KeyNo.)# (*61)#. The FF-key will toggle Variable Mode on/off while the
extension is idle or in an off-hook/dial-tone state. The FF-key LED will
remain lit (red) while Variable Mode is “On”. (You can also use a one-
touch key to toggle Variable Mode on and off; however, one-touch keys do
not contain an LED to indicate when Variable Mode is on.)
Variable Mode After Power-Cycling.
If Variable Mode is “On”, the
extension will stay in Variable Mode even after power-cycling (system is
powered down, then powered back up).
Incompatibility with older phone versions.
Variable Mode is available on
the 44-Series phones only.
Conditions under which Variable Mode does not work.
Variable Mode
will be temporarily overridden under the following conditions: during an
incoming message state, hold state, message-waiting state, or call-waiting
state. Incoming messages include:
CO Queuing
Incoming [trunk no.]
REV.[extension no.]
TRF.[trunk no.]
H-Recall
Call Wait
REC.[trunk no.]
Recall Hnt [Hunt Group no.]
DISA Incoming
Call [extension no.]
Transf [extension no.]
Recall [trunk no.]
HOLD Recall
To Next Page
Loading...
