Chapter 2. Attendant Features Section 700 - Operation
2-8 DBS Manual - Revised April 2000 DBS-2.3/9.2-700
Attendant-Controlled Text Assignment
(All Versions)
Description
The attendant can assign text to extensions, system speed dial numbers, and
Call Waiting/OHVA text replies without using a DSS/72 or entering the
programming mode.
Text is assigned through the dial pad on the attendant phone.
Operation
To assign names to extensions:
1. Pick up the receiver or press the
ON/OFF
key.
2. Press
PROG
.
3. Dial #2.
4. Enter the extension’s port number. (This must be entered as a 3-digit
number if CPC-B is used or a 2-digit number if CPC-A or CPC-AII is
used. If necessary add leading zeros.)
5. Press
AUTO
to backspace and erase the existing name.
6. Use the dialpad sequences shown in Table 2-1 on page 2-10 to enter
letters and/or numbers.
Press
FLASH
after each letter or number.
Press
CONF
to switch between numbers and letters.
7. To store your entry, press
HOLD.
To assign names to System Speed Dial numbers:
1. Pick up the receiver or press the
ON/OFF
key.
2. Press
PROG
.
3. Dial #1
4. Press
AUTO
.
5. Dial the desired of system speed dial number (00-89).
To Next Page
Loading...
