Panasonic VB-44210G - Additional RAI Access Method

DBS-2.3/9.2-700 DBS Manual - Revised April 2000 Page I-13
#99xxxx
(where xxxx = the site's private password)
5. After the DBS responds, type
P
and then press
Enter
.
6. Follow the directions on the screen to access the desired program. (See
“Terminal Programming Commands.”)
Terminal Programming Through DISA
Note:
The DBS must be equipped with an MFR card and an RAI card to
allow terminal programming using this method.
When programming through a DISA trunk, perform the following steps:
1. Dial into the DBS through a DISA trunk.
2. Once you are connected, type
#6
followed by the private password from
your terminal communications program.
3. After the DBS responds with REMT>, type
P
and then press
Enter
.
4. Follow the directions on the screen to access the desired program. (See
“Terminal Programming Commands.”)
Terminal Programming Through a CO Trunk and Operator Transfer
Note:
The DBS must be equipped with an MFR card and an RAI card to
allow terminal programming using this method.
SPECIAL NOTICE: If you use the following method, the private password
must be given to the attendant. Use the new RAI access method instead. (See
“Additional RAI Access Method”)
When programming through a normal trunk, perform the following steps:
1. Dial into the DBS through a normal trunk.
2. Ask the operator to place you on hold and dial
#6
followed by the private
password to transfer you into remote programming.
3. After the DBS responds with REMT>, type
P
and then press
Enter
.
4. Follow the directions on the screen to access the desired program. (See
“Terminal Programming Commands.”)