Panasonic WV-SP302 - Host authentication settings

73
[Host auth.]
Select"On"or"Off"todeterminewhetherornotto
authenticate the host.
Default:Off
[IP address]
Enter the IP address of the PC to be allowed to access
the camera. Host name cannot be entered for the IP
address.
Note:
 • When"IPaddress/subnetmask"isentered,itis
possible to restrict PCs in each subnet.
  Forexample,when"192.168.0.1/24"isenteredand
"2. Camera control" is selected for the access level,
the PCs whose IP address is between "192.168.0.0"
- "192.168.0.255" can access the camera with the
access level "2. Camera control".
 • WhentheIPaddressalreadyinuseisenteredand
the [Set] button is clicked, the respective host infor-
mation will be overwritten.
[Access level]
Select the access level of the host from the following.
1. Administrator/2. Camera control/3. Live only
Refer to page 72 for further information about the
access level.
Default: 3. Live only
[Host check]
By clicking [C] of "Host check", the registered host can
be selected and the selected host’s IP address can be
checked.
The registered IP address will be displayed with the
accesslevel.(Example:192.168.0.21[1])
To delete the registered host, click the [Delete] button
after selecting the IP address to be deleted.
Configure the settings relating to the host authentication [Host auth.]
Click the [Host auth.] tab on the "User mng." page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The restriction settings of PCs (IP address) from accessing the camera can be configured on this page.