Panasonic WV-SP302

89
Reset the settings/Reboot the camera [Default reset]
Click the [Default reset] tab of the "Maintenance" page. (☞ Pages 22 and 23: How to display/operate the setup
menu)
The settings and the HTML data of the camera can be initialized and reboot of the camera can be performed on
this page.
[Reset to the default (Except the network settings)]
Clickthe[Execute]buttontoresetthesettingstothe
default. Note that the network settings will not be reset.
It is impossible to operate the camera for around 2 min-
utes after the initialization.
[Load the default HTML files (setup menu).]
Clickthe[Execute]buttontoresettheHTMLfilestothe
default.
It is impossible to operate the camera for around 2 min-
utes after the initialization.
[Reset to the default and load the default HTML
files.]
Clickthe[Execute]buttontoresetthesettingsofthe
camera and the HTML files to the default. Note that the
network settings will not be reset.
It is impossible to operate the camera for around 2 min-
utes after the initialization.
[Reboot]
Clickthe[Execute]buttontorebootthecamera.Itis
impossible to operate the camera for around 2 minutes
after rebooting the camera.
Note:
 • Toinitializethenetworksettings(☞ page 78), turn
off the power of the unit, then turn on the power
again while holding down the [INITIAL SET] button
on the unit for 5 seconds.Wait around 2 minutes
after releasing the button. The unit will start up and
the settings including the network settings will be
initialized. Do not turn off the power of the unit
around 2 minutes just after turning on the power.
 • Thenotificationfunctionallowsuserstoprovidethe
notification of the error to the specified mail address
and an original alarm destination when an error such
as no SD memory card insertion after the reboot or
a locked SD memory card insertion occurs.
(☞ Pages 67 and 68)