Panasonic WV-SP302

88
Upgrade the firmware [Upgrade]
Click the [Upgrade] tab of the "Maintenance" page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The current firmware can be checked and upgraded to the latest version on this page. Contact the dealer for further
information about the firmware upgrade.
[Model no.], [MAC address], [Serial no.], [Firmware
version], [IPL version], [HTML version], [IP
address(IPv6)], [Viewer software installation coun-
ter]
Information of each item will be displayed.
Step 1
Contact the dealer and download the latest firmware
onto a PC.
Important:
 • Ablank(space)cannotbeusedforthenameofthe
directory where the downloaded firmware to be
saved.
Step 2
Click the [Browse...] button and designate the down-
loaded firmware.
Step 3
Click the radio button respective to the desired option
to determine whether or not to initialize the settings
after completing the firmware upgrade.
Note:
 • Note that the settings cannot be restored after an
initialization is operated.
Step 4
Clickthe[Execute]button.
→ The confirmation window will be displayed. When
"Do not reset the settings to the default after the
upgrade." is selected, the confirmation window will
not be displayed.
Important:
 • Aftercompletingtheupgrade,deletetemporary
internet files. (☞ Page 96)
 • UpgradethefirmwareusingaPCinthesamesub-
net as the camera.
 • Followtheinstructionsfromthedealerwhen
upgrading the firmware.
 • Usethedesignatedfile(extension:img)forthefirm-
ware upgrade.
 • Use the designated file, sp305_xxxx.img, for the
firmware upgrade.
* ("xxxx" indicates the version of the firmware.)
 • Donotturnoffthepowerofthecameraduringthe
upgrade process.
 • Donotperformanyoperationduringupgradingand
wait until it completes.
 • Thefollowingnetworksettingswillnotbereset
when upgrading the firmware after selecting "Reset
the settings to the default after completing the
upgrade.(Exceptthenetworksettings)".
  On/OffforDHCP,IPaddress,subnetmask,default
gateway, HTTP port, line speed, bandwidth control
(bitrate),time&date
 • TheviewersoftwareusedoneachPCshouldbe
licensed individually. Refer to your dealer for the
software licensing.