Panasonic WV-SP302

60
Configure the alarm settings [Alarm]
The settings relating to alarm occurrences such as settings for the alarm action at an alarm occurrence, the VMD
area settings, and the alarm occurrence notification can be configured on this page.
The "Alarm" page has 3 tabs; the [Alarm] tab, the [VMD area] tab and the [Notification] tab.
Configure the settings relating to the alarm action [Alarm]
Click the [Alarm] tab on the "Alarm" page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The settings relating to the alarm can be configured in this section.
■ Alarm
[Terminal]
Determine how to use the terminals.
Alarm input: Receives alarms.
Black & white mode:Receivestheblack&whiteswi-
tchoverinput.(WhentheinputissettoOn,theblack
&whitemodeisactivated.)
SP306
Off: Not used.
Default:Off
Note:
 • Refertotheinstallationguideforfurtherinformation
about input/output terminals.
[VMD alarm]
When clicking "VMD>>", the [VMD area] tab of the
"Alarm" page will be displayed.
[Command alarm]
Select"On"or"Off"todeterminewhetherornotto
receive the command alarm.
The command alarm is the function that provides notifi-
cation of a Panasonic protocol alarm from the other
cameras.When"On"isselected,alarmactionswillbe
performed between multiple cameras.
Default:Off
[Originating port number]
Select a port number to be used to receive the com-
mand alarm.
Available range: 1-65535
Default: 8181