[ILDA Mode]
The ILDA mode menu option will only become available when an ILDA daughterboard is
connected to the FB4. ILDA mode allows you to connect an ILDA cable from another
controller. The ILDA daughter board support ILDA in and Through.
During this operation mode, the following menu options will be available.
[Operation mode]
[Master settings] (See page 11)
[Color Settings] (See page 14)
[Scan Guard] (See page 14)
[Network Setup] (See page 15)
[FB4 Device Info] (See page 15)
Note: The ILDA daughterboard can NOT send out ILDA signals from QuickShow or
BEYOND.
[Test Mode]
The [test mode] has been created to give you the ability to open up a test frame without the
need to connect other equipment. Test frames will need to be prepared and uploaded through
Pangolin’s QuickShow or BEYOND its FB4 Export Utility. During preparation of the test
frames an ethernet cable is required. Once the test frames are located on the SD card of the
FB4, there is no cable connection needed to activate [test mode].
During this operation mode, the following menu options can be controlled.
[Operation Mode]
[Master Settings] (See page 11)
[Test mode Setup] (See page 13)
[Geo Correction] (See page 14)
[Color Settings] (See page 14)
[Scan Guard] (See page 14)
[FB4 Device Info] (See page 15)
[Exit Menu] (See page 15)
To Next Page
Loading...
General