[Slave Mode]
[Autoplay] allows for scheduling shows across multiple projectors. When setting up a show
which uses multi FB4’s, one laser will need to act as master. This laser will need to be set in
operational mode [Autoplay]. Other FB4’s that need to perform in the same show, must be
placed in operation mode [Slave mode] so that they will follow the master FB4.
For the master/slave functionality to work, all FB4’s need to be connected to the same
ethernet network.
During this operation mode, the following menu options will be available.
[Master Settings] (See page 11)
[Geo Correction] (See page 14)
[Color Settings] (See page 14)
[Scan Guard] (See page 14)
[FB4 Device Info] (See page 15)
[Time Code]
The [Time code] mode allows you to start the FB4 to play based on an incoming Artnet Time
code signal (ATC for short). The content that will be played, will need to be prepared through
QuickShow or BEYOND. This requires an ethernet connection.
During this operation mode, the following menu options will be available.
[Operation Mode]
[Time Code Setup] (See page 13)
[Master Settings] (See page 11)
[Geo Correction] (See page 14)
[Color Settings] (See page 14)
[Scan Guard] (See page 14)
[FB4 Device Info] (See page 15)
To Next Page
Loading...