[Artnet settings]
The Artnet protocol allows you to control the FB4 as DMX fixture over ethernet directly
from a console or other application using a network cable. When the FB4 is in operation
mode [Artnet], the [Artnet Settings] menu allow you to adjust the fixture presets. The FB4
offers two Fixture profile layouts. A 16-channel and a 39-channel layout. Artnet settings will
be saved when powering down the FB4. More information about the different fixture layouts
on page 20
[Universe] Determines the universe the FB4 fixture is operating on
[Start Address] Determines the start address of the FB4 Fixture
[Profile] Determines which Fixture profile is active.
[FB3] 16-channel DMX/Artnet fixture profile is active
[FB4] 39 channel DMX/Artnet fixture profile is active
[Timeout] The FB4 has an adjustable timeout period for Artnet. If no
Artnet frames where received within the specified period, output will
stop. This value should be adjusted so that output does not stop too
early, when the ArtNet framerate is low, but still in a timely manner
when the ArtNet source disappears. (the default value is 3.0)
[DMX settings]
The DMX settings menu allows you to control the FB4 as DMX fixture over XLR DMX
Cables directly from a console or other DMX equipment. When the FB4 Is on operation
mode [DMX-512], the menu [DMX-settings] becomes available and allows you to adjust the
fixture presets. The FB4 offers two different fixture profile layouts. A 16-channel and a 39-
channel layout. DMX settings will be saved when powering down the FB4. More information
about the different Fixture layouts on page 20.
[Start Address] Determines the DMX start address of the FB4 Fixture.
[Termination] Determines if the FB4 will terminate the DMX cable after the DMX
signal comes in. Termination is done at 120Ω
[Auto] - The FB4 determines itself if termination is needed
[On] - Termination is always enabled
[Off] - Termination is always disabled.
[Profile] Determines which Fixture profile is active.
[FB3] - 16 channel DMX/Artnet fixture profile is active
[FB4] - 39 channel DMX/Artnet fixture profile is active
[Timeout] The FB4 has an adjustable timeout period for DMX. If no
DMX frames where received within the specified period, output will
stop. This value should be adjusted so that output does not stop too
early, when the DMX framerate is low, but still in a timely manner
when the DMX source disappears. (the default value is 3.0)
To Next Page
Loading...
General