EasyManuals Logo

Pangolin FB4 SE User Manual

Pangolin FB4 SE
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
FB4 SE manual Version 0.91 Beta
15
[Network Setup]
[Network setup] allows you to change the IP configuration of the FB4. The IP address is the
address where the FB4 can be found on an ethernet network. An IP address can be predefined
in the configuration of the FB4, it can be received from the DHCP server or generate a
APIPA IP address on its own.
The FB4 can operate with and without a DHCP server on the network. If no DHCP server is
detected, the FB4 will generate an IP address on its own witch will allow the FB4 to operate
with QuickShow or BEYOND.
The Subnet Mask defines the range where the FB4 can be found. The default settings for the
FB4 [Auto IP] is on and the subnet mask is 255.255.255.0. Settings are saved on the SD
card.
[Auto IP] When enabled, the FB4 will search for a DHCP server and when none is found
it will allow for generation of an APIPA address.
[Address 1] Allows you to change the first part of the IP address (e.g. XXX.168.0.10)
[Address 2] Allows you to change the second part of the IS address (e.g. 192.XXX.0.10)
[Address 3] Allows you to change the third part of the IP address (e.g. 192.168.XXX.10)
[Address 4] Allows you to change the forth part of the IP address (e.g. 192.168.0.XXX)
[Mask 1] Allows you to change the first part of the subnet mask (e.g. XXX.255.255.0)
The default value is 255
[Mask 2] Allows you to change the first part of the subnet mask (e.g. 255.XXX.255.0)
The default value is 255
[Mask 3] Allows you to change the first part of the subnet mask (e.g. 255.255.XXX.0)
The default value is 255
[Mask 4] Allows you to change the first part of the subnet mask (e.g. 255.255.255.X)
The default value is 0
[FB4 Device Info]
The [FB4 Device info] menu shows the serial number of the FB4. The firmware version that
is installed and the build number of the firmware. This menu has no further function other
than informational.
[Exit Menu]
The Exit menu allows you to close the menu, turning the display off again.
This is also the moment that all settings and values are saved on the SD card.
Especially handy when replacing an SD card.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pangolin FB4 SE and is the answer not in the manual?

Pangolin FB4 SE Specifications

General IconGeneral
BrandPangolin
ModelFB4 SE
CategoryServer
LanguageEnglish