[Autoplay]
The Autoplay mode allows one or more lasers to start and play content at specific predefined
times or when the power of the laser is turned on. Autoplay requires that content is prepared
through the FB4 export Utility inside QuickShow or BEYOND. This wizard will also allow
you to schedule the shows that are stored on the SD card. Preparing content for automatic
playback requires an ethernet connection with QuickShow or BEYOND. The actual playback
does not require any cable connection.
During this operation mode, the following menu options will be available.
[Autoplay Setup] (See page 8)
[Master Settings] (See page 11)
[Geo Correction] (See page 14)
[Color Settings] (See page 14)
[Scan Guard] (See page 14)
Note: When scheduled content needs to be played on specific date and times, installation of a
battery is needed. As deliverd, FB4 comes without battery. A battery can be installed to
enable the real-time clock. Date and time can be setup through the QuickShow or BEYOND
FB4 Export utility. The battery type required for this purpose is “CR1220”. The battery can
be installed by pointing the negative side of the battery towards the circuit board.
To Next Page
Loading...
General