Troubleshooting
Problem: No laser output when I use beams.
Resolution: Check if the scan fail function is disabled (see page 14)
Problem: The software does not find the FB4.
Resolution Make sure the hardware is in operation mode [BEYOND/QS] and
Make sure that in [Network Setup], [Auto IP] is Enabled.
Problem: There is no ILDA out on the external ILDA daughterboard in
[BEYOND/QS] mode
Resolution Connect the scanners and diode drivers, directly to the FB4. (See pages
26-27)
Problem: The output of the lasers is flickering in [DMX-512]/[Art-net] modes
Resolution: Try to raise or lower the [DMX-512]/[Art-net] [timeout] settings. (see
page 12)
To Next Page
Loading...